Last Modified: 11-29-2007 1.6 A
Service Category: Engine/Hybrid System Section: Engine Control
Model Year: 2008 Model: Sequoia Doc ID: RM000002H5900HX
Title: 3UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: INSTALLATION (2008 Sequoia)

INSTALLATION

1. INSTALL POWER STEERING OIL PRESSURE SWITCH

(a) Install a new O-ring to the oil pressure switch.

(b) Apply a light coat of engine oil to the O-ring of the oil pressure switch.

NOTICE:

  • When reusing the oil pressure switch, inspect the O-ring.
  • If the O-ring has scratches or cuts, replace the oil pressure switch.


(c) Using a 24 mm deep socket wrench, install the oil pressure switch.

Torque: 21 N·m (214 kgf·cm, 16 ft·lbf)

(d) Connect the oil pressure switch connector.

2. ADD POWER STEERING FLUID

3. BLEED POWER STEERING FLUID POWER ASSIST SYSTEMS: POWER STEERING SYSTEM: ON-VEHICLE INSPECTION (2008 Sequoia)+

4. INSPECT FOR POWER STEERING FLUID LEAK

5. INSTALL FRONT FENDER APRON SEAL RH 3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: INSTALLATION (2008 Sequoia)+